Stihl MS 200 Service Manual page 54

: Take out the screw (arrow).
: Remove annular buffer from the
oil tank, b 11.2
– Lift the handle housing slightly
and pull out the wiring harness.
: Disconnect wiring harness (1)
from the short circuit wire
connector (2).
MS 200 T
2
: Take out the screws (arrows).
– Remove the control lever (1) and
handle molding (2).
MS 200, MS 200 T
– Remove the switch shaft (1),
b 12.1.2
– Remove the annualr buffer from
the oil tank, b 11.2.1
2
1
1
– Pull out the contact spring (1).
: Disconnect the short circuit wire
(2).
MS 200, MS 200 T
1
1
: Pry out the grommet (1).
1
1
– Pull out the ignition lead, b 9.3
: Pry out the grommet (1) and take
it off the connector (2).
2
1
: Tie a piece of string to the
connector (arrow).
2
53