Stihl MS 200 Service Manual page 36

– Lubricate the piston, piston rings
and cylinder wall with oil, b 16
: Use the clamping strap (1)
0000 893 2600 to compress the
rings around the piston.
– Check correct installed position
of rings, b 8.7
Apply the clamping strap (1) so that
the piston rings do not project
beyond the cylinder wall.
: Align the cylinder so that the
intake port (1) points towards the
nipple for the impulse hose.
While sliding the cylinder over the
piston, hold the clamping strap
tightly around the piston so that the
rings do not project – they might
otherwise break.
– Slide the cylinder over the piston,
the clamping strap moves
downwards at the same time.
MS 200, MS 200 T
1
2
: Remove the clamping strap (1)
and wooden assembly block (2).
Make sure the cylinder gasket is
properly seated.
1
– Push the cylinder fully home.
: Insert the screws (arrows) to hold
the cylinder and gasket in
position.
– Tighten down the screws in an
alternate pattern.
– Tightening torques, b 3.5
1
1
: Push the impulse hose (1) on to
the nipple (arrow).
– Install the tank housing, b 14.8
When installing the handle housing,
check that the impulse hose is
properly fitted on the nipple, MS 200
b 12.4, MS 200 T b 12.5.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
35