Stihl MS 200 Service Manual page 69

Version with anchor loop
pointing outwards
The same procedures are used
here as for the 'version with anchor
loop pointing inwards'.
The differences are the anchor loop
and the installed position of the
spring.
2
1
: Line up the replacement spring
with frame – the anchor loop (2)
must be above the lug (1).
– Fit the rewind spring with frame in
position.
Make sure the starter post does not
touch the inner spring loop in this
process – the spring may pop out
and uncoil.
: Push the rewind spring through
the frame and into its seat in the
fan housing.
68
If the rewind spring has popped out,
refit it in the fan housing as follows:
1
: The open side of the anchor loop
(arrow) must face outwards.
Then fit the rewind spring (1)
counterclockwise.
The procedure is now the same as
for the 'version with anchor loop
pointing inwards'.
1
Check that the rewind spring (1) is
properly seated and the anchor loop
engages the lug (arrow).
– Secure the spring so that it
cannot pop out.
– Remove the rope rotor, b 10.4
– Install the pawl, b 10.3
– Lubricate peg on pawl with
grease, b 16
– Tension the rewind spring,
b 10.6
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
MS 200, MS 200 T