Stihl MS 200 Service Manual page 114

1
: Pull out the insulating plate (1).
– Inspect the insulating plate (1)
and heat shield (2) and replace if
necessary, b 8.1
1
: Lift tank housing (1) into position
so that opening (arrow) is above
the intake manifold.
2
1
: Push the impulse hose (1)
through the hole (arrow).
– Line up tank housing (2) with
holes.
MS 200, MS 200 T
2
: Fit the screws (arrows).
– Turn the machine over.
: Fit the screws (arrows).
– Check that tank housing is
properly seated, line up if
necessary and then tighten down
the top and bottom screws firmly.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 3.5
113