Stihl MS 200 Service Manual page 47

2
1
: Unscrew the ignition module (1)
from the ignition lead (2).
– Check the ignition module (1) and
replace if necessary
1
: Use a suitable punch to drive out
the retainer (1).
– Check the retainer and replace if
necessary
– Check the spark plug boot and
ignition lead, and replace if
necessary, b 9.3
– Reassemble in the reverse
sequence.
– Troubleshooting, b 4.5
46
The flywheel is not shown in the
illustration.
Before installing the ignition
module, check that the ignition lead
and short circuit wire are properly
seated in the recess (arrow) and do
not touch the flywheel
– there is otherwise a risk of
damaging the insulation and
causing a short circuit.
2
1
: Attach the connector (1) to the
tag and push the short circuit wire
(2) into the retainer (arrow).
– The short circuit wire is now held
in position and can be
disconnected again from the
ignition module.
1
: Place the ignition module (1) in
position and insert the screws
with washers (arrows) – do not
tighten down yet.
1
– Push the ignition module (1) back
– the flywheel must turn freely.
: Rotate the flywheel until the
magnet poles (arrows) are next to
the ignition module.
MS 200, MS 200 T