Stihl MS 200 Service Manual page 39

3
2
The short circuit wire (1) with
grommet (2) must be positioned
kink-free in the ignition side of the
crankcase so that the connector (3)
locates against the grommet.
The grommet must engage the
clutch side of the crankcase (arrow).
Make sure the sleeves (arrows)
engage the holes and the gasket is
not pinched or twisted.
– Hold the oil suction hose in the
crankcase so that it is not
pinched during assembly.
– Push the clutch side (1) of the
crankcase into position as far as
stop.
38
1
: Insert the screws (arrows) and
tighten them down firmly in an
alternate pattern.
– Tightening torques, b 3.5
1
1
: Push the ignition lead (1) through
the hole (arrow) in the clutch side
of the crankcase.
2
1
– The short circuit wire must be in
the smaller hole (arrow) in the
grommet.
– Using STIHL Press Fluid
simplifies the job of pushing the
ignition lead (1) through the
grommet, b 16
: Push the ignition lead (1) through
the grommet (2).
– Check and install the piston,
b 8.6.2
– Check and install the cylinder,
b 8.4
– Reassemble all other parts in the
reverse sequence.
MS 200, MS 200 T