Stihl MS 200 Service Manual page 41

1
– Heat the area of the bearing seat
to about 230°C (446°F).
The roller bearing (1) drops out as
soon as this temperature is
reached.
– Heat the area of the bearing seat
to about 230°C (446°F).
– Position the roller bearing so that
the nylon ring faces outwards.
: Push the roller bearing home as
far as stop.
This operation must be carried out
quickly because the bearing
absorbs heat and begins to expand.
40
Clutch side of crankcase
: Use a suitable punch to carefully
drive out the oil seal.
: Check and clean the crankcase
or replace if necessary.
If this half of the crankcase is in
order, install a new roller bearing.
1
– Heat the area of the bearing seat
to
about 230°C (446°F).
The roller bearing (1) drops out as
soon as this temperature is
reached.
– Heat the area of the bearing seat
to
about 230°C (446°F).
– Position the roller bearing so that
the nylon ring faces outwards.
: Push the roller bearing home as
far as stop.
This operation must be carried out
quickly because the bearing
absorbs heat and begins to expand.
After the crankcase halves have
cooled, fit the short circuit wire in the
ignition side of the crankcase.
2
: Push the grommet (1) –
rectangular opening first – over
the connector (2).
MS 200, MS 200 T
1