Admin | Pap Save - Comtech EF Data CDM-570A Installation And Operation Manual

7.4.3.2.8

Admin | PaP Save

This page is available only when you install the optional Packet Processor.
You must click [Save PaP Parameters] on this page, in addition to changes made to the
following CDM-570A HTTP Interface pages:
Admin | Pap Features
Admin | Firmware | Packet Processor
Configuration | LAN (only when the optional Packet Processor is
INSTALLED)
Configuration | ARP
Any nested Configuration | Routing page
Configuration | Managed Switch
Any nested Configuration | WAN page
Redundancy (only when the optional Packet Processor is INSTALLED)
Note that the modem reboots automatically if any changes are submitted to the 'Admin |
Working Mode' page (see Sect. 7.4.3.2.3).
Ethernet-based Remote Product Management
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Figure 7-13. Admin | PaP Save Page
CDM-570A HTTP Interface Page
7–26
Revision 5
Section
7.4.3.2.4
7.4.3.2.5.2
7.4.3.3.2
7.4.3.3.3
7.4.3.3.4
7.4.3.3.5
0
7.4.3.6
MN-CDM570A