Reed-Solomon (Rs) Outer Codec; Closed Network Modes - Comtech EF Data CDM-570A Installation And Operation Manual

70/140 mhz/l-band/reduced chassis depth/with optional high performance packet processor
Hide thumbs Also See for CDM-570A:
Table of Contents

Advertisement

B.3

Reed-Solomon (RS) Outer Codec

The concatenation of an outer Reed-Solomon (RS) Codec with Viterbi decoder first became popular
when it was introduced by Intelsat in the early 1990s. It permits significant improvements in error
performance without significant bandwidth expansion. The coding overhead added by the RS outer
Codec is typically around 10%, which translates to a 0.4 dB power penalty for a given link.
RS codes are block codes – as opposed to Viterbi, which is convolutional; in order to be
processed correctly, the data must be framed and de-framed. Additionally, RS codes are limited
in how well they can correct errors that occur in bursts. This, unfortunately, is the nature of the
uncorrected errors from Viterbi decoders, which produce clusters of errors that are multiples of
half the constraint length. For this reason, the data must be interleaved following RS encoding,
and is then de-interleaved prior to decoding. This ensures that a single burst of errors leaving the
Viterbi decoder is spread out over a number of interleaving frames, so errors entering the RS
decoder do not exceed its capacity to correct those errors.
B.3.1

Closed Network Modes

A 220,200 code is used in transparent closed network modes, and a 200,180 code is used in
framed (EDMAC) modes. (220,200 means that data is put into blocks of 220 bytes, of which 200
bytes are data, and 20 bytes are FEC overhead.)
When Viterbi decoding is used as the primary FEC, an interleaver depth of 4 is used. The
increase in coding gain is at the expense of delay. The interleaving/de-interleaving delay and the
delay through the decoder itself can be as high as 25 kbits. At very low data rates, this equates to
several seconds, making it highly unsuitable for voice applications. Additionally, the de-interleaver
frame synchronization method can add significantly to the time taken for the demodulator to
declare acquisition.
FEC (Forward Error Correction) Options
CDM-570A/570AL Satellite Modem with Optional Packet Processor
B–3
Revision 5
MN-CDM570A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdm-570alCdmr-570al

Table of Contents