Call Features Settings Parameters - Avaya E129 Administering

Administering through the configuration file

Call features settings parameters

Parameter Default value
P71
P1485 30
P91 0
P186 0
P184 0
P338 0
P1565 0
P1525
P1376 0
June 2016
Description
Specifies the number that the deskphone dials when the deskphone is off-
hook.
Specifies the time in seconds after which the deskphone goes on-hook
after being off-hook. You can specify any value in the range of 10 to 60.
Specifies whether to disable the call waiting feature. Assign any of the
following values:
• 0: No
• 1: Yes
Specifies whether to disable the call waiting tone when the Call Waiting
feature is active. Assign any of the following values:
• 0: No
• 1: Yes
Specifies whether the user can dial an IP address under the same LAN or
VPN segment by entering the last octet in the IP address. Assign any of
the following values:
• 0: No
• 1: Yes
Specifies whether the deskphone displays the DTMF digits that the user
enters during a call. Assign any of the following values:
• 0: No
• 1: Yes
Specifies whether to enable the Idle Mute feature. Assign any of the
following values:
• 0: No
• 1: Yes
Specifies the number that the deskphone dials as DTMF when the user
presses the Transfer button
Specifies whether the deskphone uses the attended transfer by default.
Assign any of the following values:
• 0: No
• 1: Yes
Note:
Only blind transfer is supported if both the lines are occupied.
Administering Avaya E129 SIP Deskphone
Comments on this document? infodev@avaya.com
Table continues...
82