Fujitsu fi-4860C Operator's Manual page 251

At this screen, press
select scan resolution. Following parameters can be specified.
200:
240:
300:
400 sheets: Scan at 400 dpi
Press
redisplayed.
(5) Press
At <Screen51-1>, select [START] and press
If fi-486PRFR and/or fi-486PRREis installed, <Screen51-3> is displayed for
you to setup imprinter test conditions.
If an imprinter(s) is not installed, the scanner starts scanning operations.
6) At <Screen50-3>, press
Select [On] to do imprinter test while scanning.
Then, select the imprinter to use.
If the printer to use is fi-486PRFR, select [Pre].
If fi-486PRRE, select [Post].
If imprinter test is not required, select [Off].
228
7.5 Test Mode Details
<Screen51-2.4>
R E
(Left arrow button) or
Scan at 200 dpi
Scan at 240 dpi
Scan at 300 dpi
(Enter button) and confirm the setting. Then <Screen51-2> is
(Enter button). Then <Screen51-1> is redisplayed.
<Screen51-3>
= O f f
(Left arrow button) or
S O U T I O
L
2 0 0
(Right arrow button) and
(Start button).
n t
P r i
/ n : P r e
O
(Right arrow button) and:
N
/ P o s t