Fujitsu fi-4860C Operator's Manual page 157

Are the Pick roller unit and the
Brake roller unit installed properly?
Have you scanned many sheets?
Check the consumables life to ensure
you have not scanned more than
300,000 sheets. (* 7)
Contact an authorized FUJITSU
Scanner service provider.
(* 1) For the details on required conditions, refer to the section "6.2 Document Quality"
on page 147.
(* 2) For the double-feed detection conditions, refer to "Appendix 2 Double-feed
Detection Conditions" on page AP-2.
(* 3), (* 5) For the details on how to clean scanner, refer to "Chapter 3 DAILY CARE" on
page 41.
(* 4) For the details on how to replace Pas ASSY, refer to "Chapter4 REPLACING
CONSUMABLES" on page 89.
(* 6) For the details on how to replace and install Pick roller unit and Brake roller unit,
refer to "Chapter 4 REPLACING CONSUMABLES" on page89.
(* 7) Check the wear of rollers. For the method to check the number of sheets scanned
for each consumable, refer to "7.3 Setup Mode Details", "9. Abrasion counter reset"
on page 186.
134
5.2 Troubleshooting
Continued from the previous page
NO
Brake roller properly. (* 6)
YES
YES
Replace the Pick roller unit and
the Brake roller unit if
necessary. (*6)
NO
nstall the Pick roller and the