Feeding Roller - Canon iR4570 Series Service Manual

8.8.19.4 Removing
Registration Clutch
iR2270 / iR2870 / iR3570 / iR4570 / iR3530
1) Disconnect the connector (2P) [1], and free the
cable from the edge saddle [2] and the 3 wire
saddles [3].
2) Remove the E-ring [4], and detach the registration
clutch [5].
F-8-352

8.8.20 Feeding Roller

8.8.20.1 Removing the Pickup
Roller/Feed
Separation Roller
iR2270 / iR2870 / iR3570 / iR4570 / iR3530
1) Slide out the cassette.
2) Open the right door (in the case of the separation
roller).
3) Pick the tabs of the individual rollers, and detach
the pickup roller [1], feed roller [2], and separation
roller [3].
the
0007-6723
Roller/
0008-3154
F-8-353
Point to Note When Replacing the Feed/Separation
Roller 1
The collar (roller core) of the machine's feed/
separation roller is black.
8.8.21 Vertical Path Roller
8.8.21.1 Removing the Right
Cover (rear)
iR2270 / iR2870 / iR3570 / iR4570 / iR3530
1) Open the pedestal right door [1]. (if equipped with
a 2-Cassette Pedestal-Y2)
2) Open the right lower door [2].
3) Remove the 5 screws [3], and detach the right cover
(rear) [4].
Chapter 8
0007-6736
8-133