Removing The Toner Feedscrew Motor - Canon iR4570 Series Service Manual

F-7-121
2) Disconnect the 3 connectors [1] found at the front
and the connector [2] found at the rear.
F-7-122
3) Open the 11 wire saddles [1], and pull out the
harness [3] through the hole [2] in the plate.
F-7-123
4) Remove the 3 screws [1], and detach the hopper
assembly [2].
F-7-124
When fitting the hopper assembly to the machine, be
sure that the connectors [1] are securely connected. If
the connectors [1] are not connected, the environment
heater will not be supplied with power, leading to
image faults.
F-7-125
7.12.4.12 Removing the Toner
Feedscrew Motor
iR2270 / iR2870 / iR3570 / iR4570 / iR3530
1) Disconnect the connector [1].
Chapter 7
0007-8395
7-47