Juniper EX9200 Features Manual page 337

Options
Copyright © 2017, Juniper Networks, Inc.
—(TX Matrix routers and TX Matrix Plus routers only) (Optional) On a TX Matrix
all-chassis
router, display graceful Routing Engine switchover information for all Routing Engines
on the TX Matrix router and the T640 routers configured in the routing matrix. On a
TX Matrix Plus router, display graceful Routing Engine switchover information for all
Routing Engines on the TX Matrix Plus router and the T1600 or T4000 routers
configured in the routing matrix.
—(TX Matrix routers and TX Matrix Plus routers only) (Optional) On a TX Matrix
all-lcc
router, display graceful Routing Engine switchover information for all T640 routers
(or line-card chassis) connected to the TX Matrix router. On a TX Matrix Plus router,
display graceful Routing Engine switchover information for all connected T1600 or
T4000 LCCs.
Note that in this instance, packets get dropped. The LCCs perform GRES on their
own chassis (GRES cannot be handled by one particular chassis for the entire router)
and synchronization is not possible as the LCC plane bringup time varies for each
LCC. Therefore, when there is traffic on these planes, there may be a traffic drop.
all-members —(MX Series routers only) (Optional) Display graceful Routing Engine
switchover information for all Routing Engines on all members of the Virtual Chassis
configuration.
—(TX Matrix routers and TX Matrix Plus routers only) (Optional) On a TX
lcc number
Matrix router, display graceful Routing Engine switchover information for a specific
T640 router connected to the TX Matrix router. On a TX Matrix Plus router, display
graceful Routing Engine switchover information for a specific router connected to
the TX Matrix Plus router.
Replace number with the following values depending on the LCC configuration:
0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
—(MX Series routers only) (Optional) Display graceful Routing Engines switchover
local
information for all Routing Engines on the local Virtual Chassis member.
member member-id —(MX Series routers only) (Optional) Display graceful Routing Engine
switchover information for all Routing Engines on the specified member of the Virtual
Chassis configuration. Replace
scc —(TX Matrix router only) (Optional) Display graceful Routing Engine switchover
information for the TX Matrix router (or switch-card chassis).
—(TX Matrix Plus routers only) (Optional) Display graceful Routing Engine switchover
sfc
information for the TX Matrix Plus router.
Chapter 26: Operational Commands
with a value of 0 or 1.
member-id
317