Vrrp-Group - Juniper EX9200 Features Manual

vrrp-group

Syntax
Hierarchy Level
Release Information
Description
Options
Copyright © 2017, Juniper Networks, Inc.
vrrp-group group-id {
(accept-data | no-accept-data);
advertise-interval seconds;
advertisements-threshold number;
authentication-key key;
authentication-type authentication;
fast-interval milliseconds;
(preempt | no-preempt) {
hold-time seconds;
}
priority number;
track {
interface interface-name {
bandwidth-threshold
priority-cost priority;
}
priority-hold-time seconds;
route prefix/prefix-length routing-instance instance-name priority-cost priority;
}
virtual-address [ addresses ];
vrrp-inherit-from vrrp-group;
}
[edit interfaces interface-name unit logical-unit-number family inet address address],
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number
family inet address address]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS 11.3 for the QFX Series.
Statement introduced in Junos OS Release 14.1x53-D20 for the OCX Series.
Configure a Virtual Router Redundancy Protocol (VRRP) IPv4 group. As of Junos OS
Release 13.2, VRRP nonstop active routing (NSR) is enabled only when you configure the
statement at the
nonstop-routing
logical-system-name routing-options
NOTE: The group identifier that you enter must be different from any other
group identifiers that you configured for logical units of this same physical
interface.
—VRRP group identifier. If you enable MAC source address filtering on the
group-id
interface, you must include the virtual MAC address in the list of source MAC
addresses that you specify in the
ranging from 00:00:5e:00:53:00 through 00:00:5e:00:53:ff are reserved for VRRP,
as defined in RFC 2338. The VRRP group number must be the decimal equivalent
of the last hexadecimal byte of the virtual MAC address.
Range: 0 through 255
Chapter 24: Configuration Statements: VRRP
bits-per-second priority-cost priority;
[edit routing-options]
hierarchy level.
source-address-filter
or
[edit logical system
statement. MAC addresses
285