Vrrp-Inet6-Group - Juniper EX9200 Features Manual

vrrp-inet6-group

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Copyright © 2017, Juniper Networks, Inc.
vrrp-inet6-group group-id {
(accept-data | no-accept-data);
advertisements-threshold number;
fast-interval milliseconds;
inet6-advertise-interval seconds;
(preempt | no-preempt) {
hold-time seconds;
}
priority number;
track {
interface interface-name {
bandwidth-threshold
priority-cost priority;
}
priority-hold-time seconds;
route prefix/prefix-length routing-instance instance-name priority-cost priority;
}
virtual-inet6-address [ addresses ];
virtual-link-local-address
vrrp-inherit-from vrrp-group;
}
[edit interfaces interface-name unit logical-unit-number family inet6 address address],
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number
family inet6 address address]
Statement introduced before Junos OS Release 7.4.
Configure a Virtual Router Redundancy Protocol (VRRP) IPv6 group.
NOTE: The group identifier that you enter must be different from any other
group identifiers that you configured for logical units of this same physical
interface.
—VRRP group identifier. If you enable MAC source address filtering on the
group-id
interface, you must include the virtual MAC address in the list of source MAC
addresses that you specify in the
ranging from
00:00:5e:00:01:00
as defined in RFC 2338. The VRRP group number must be the decimal equivalent
of the last hexadecimal byte of the virtual MAC address.
Range: 0 through 255
The remaining statements are explained separately.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Chapter 24: Configuration Statements: VRRP
bits-per-second priority-cost priority;
ipv6-address;
source-address-filter
through
00:00:5e:00:01:ff
statement. MAC addresses
are reserved for VRRP,
287