Configuring Vrrp; Configuring The Startup Period For Vrrp Operations; Chapter 14 Configuring Vrrp - Juniper EX9200 Features Manual

CHAPTER 14

Configuring VRRP

Configuring the Startup Period for VRRP Operations

Copyright © 2017, Juniper Networks, Inc.
Configuring the Startup Period for VRRP Operations on page 129
Configuring Basic VRRP Support on page 130
Configuring VRRP Authentication (IPv4 Only) on page 134
Configuring the Advertisement Interval for the VRRP Master Router on page 135
Configuring a Backup Router to Preempt the VRRP Master Router on page 138
Modifying the Preemption Hold-Time Value for the VRRP Master Router on page 138
Configuring the Asymmetric Hold Time for VRRP Routers on page 139
Configuring an Interface to Accept All Packets Destined for the Virtual IP Address of a
VRRP Group on page 140
Configuring a Logical Interface to Be Tracked for a VRRP Group on page 141
Configuring a Route to Be Tracked for a VRRP Group on page 143
Configuring Inheritance for a VRRP Group on page 145
Configuring the Silent Period to Avoid Alarms Due to Delay in Receiving VRRP
Advertisement Packets on page 146
Configuring Passive ARP Learning for Backup VRRP Routers on page 147
Enabling the Distributed Periodic Packet Management Process for VRRP on page 148
Configuring VRRP to Improve Convergence Time on page 149
Configuring VRRP on page 150
Configuring VRRP for IPv6 on page 152
Configuring VRRP Route Tracking on page 153
Tracing VRRP Operations on page 154
To configure the startup period for VRRP operations, include the
statement at the
[edit protocols vrrp]
[edit protocols vrrp]
startup-silent-period seconds;
hierarchy level:
startup-silent-period
129