Juniper EX9200 Features Manual page 213

High availability feature guide ex series
Hide thumbs Also See for EX9200:
Table of Contents

Advertisement

Copyright © 2017, Juniper Networks, Inc.
NOTE:
If you include this statement, the BFD timers maintain their
original values during the unified ISSU, and the BFD sessions might flap
during the unified ISSU or Routing Engine switchover, depending on the
detection intervals.
If proxy ARP is enabled on your M Series, MX Series, or EX 9200 Series device, remove
2.
the
unconditional-src-learn
hierarchy level.
0 family inet]
By default the statement is not included. This example shows the ge-0/0/1 interface
only.
{master} [edit]
user@host# delete interfaces ge-0/0/1 unit 0 family inet unconditional-src-learn
If LACP is enabled on your PTX Series device, remove the
3.
[edit interfaces interface-name aggregated-ether-options]
{master} [edit]
user@host# delete interfaces aex aggregated-ether-options lacp
If ATM Point-to-Point Protocol (PPP) is enabled on your M Series or T Series device,
4.
set the keepalive interval to 10 seconds or greater.
PPP requires three keepalives to fail before it brings down the session. Thirty seconds
(10 seconds x three) provides a safe margin to maintain PPP sessions in case of
any traffic loss during the unified ISSU operation.
This example shows the at-0/0/1 interface only.
{master} [edit]
user@host# set interfaces at-0/0/1 unit 0 keepalives interval 10
If ATM OAM is enabled on your M Series or T Series device, set the OAM F5 loopback
5.
cell period to 20 seconds or greater to maintain ATM connectivity across the unified
ISSU.
Include the
oam-period
logical-unit-number]
the at-0/0/1 interface only.
{master} [edit]
user@host# set interfaces at-0/0/1 unit 0 oam-period 20
After you have verified your configuration and are satisfied with it, commit the
6.
changes by using the
{master} [edit]
user@host# commit
commit complete
Exit configuration mode by using the exit command.
7.
{master} [edit]
user@host# exit
{master}
statement from the
statement at the
[edit interfaces interface-name unit
hierarchy level and specify 20 seconds. This example shows
command.
commit
Chapter 17: Performing a Unified ISSU
[edit interfaces interface-name unit
statement from the
lacp
hierarchy level.
193

Advertisement

Table of Contents
loading

Table of Contents