Ricoh MP C3004 Field Service Manual page 367

8. Insert the other side of the USB cable [B] into the USB port (Type B) on this option board.
9. Attach the ferrite cores to the Ethernet cable, while looping the cable at 3 cm (approx. 1.2
inch) [A] from the each end of the cable.
10. Only for installing this option in North America, bind both cores with cable ties [A] as
shown below.
The two binds are not included in options produced before March, 2015. To bind the cores, use
the binds registered as service parts or similar ones.
USB Device Server Option Type M19 (D3BC-28,-29)
359