Fan Motor Error
Phaser 6180 Color Laser Printer Service Manual
The Fan Motor is not in operation.
Applicable Chain Link
■
Chain Link
■
Chain Link
Initial Actions
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Main Fan, PL9.1.10
■
Duplex Fan, PL11.1.25
■
Top LV Harness, PL10.1.16
■
Duplex Unit Harness, PL11.1.18
■
Front Cover Harness, PL1.2.11
■
Right Side Harness, PL10.1.15
■
LVPS, PL9.1.4
■
MCU Board, PL9.1.20
■
Duplex Unit, PL11.1.1
■
Troubleshooting Procedure Table
Step
Actions and Questions
Check the following wiring harness
1
connectors.
Between P/J503 and the Main Fan
■
Between P/J427 and the Duplex Fan
■
2
Does the error still occur?
Perform the Fan test (page 4-46):
3
Service Mode
Does the Fan operate properly?
Perform the Duplex Fan test
4
(page 4-63):
Diag
Does the Motor operate properly?
042-313: Fan Motor Error
042-358: Fan Motor Error
Wiring and Plug/Jack Map References
■
page 10-10
■
page 10-13
■
■
■
>
Engine Diag
> Fan.
Service Mode
>
Engine
>
Duplex
Fan.
Error Messages and Codes
"Map 1 - Electrical and Drive" on
"Map 4 - LVPS and MCU Board" on
"Map 5 - Duplex Unit" on page 10-14
"DC Power Supply" on page 10-30
"Duplex Wiring Diagram" on page 10-52
Yes
No
Go to step 2.
Complete.
Go to step 3.
Complete.
Go to step 4.
Go to step 10.
Replace the
Go to step 5.
MCU Board
(page 8-87).
3-81