Error Messages and Codes
Ready Fuser Life
Applicable Chain Link
Initial Actions
3-38
The Fuser has reached its end of life.
Warning
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
■
Chain Link
010-421: Ready Fuser Life
■
Check the Fuser life using CentreWare IS.
■
Cycle printer power.
■
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL6.1.10
■
MCU Board, PL9.1.20
■
Troubleshooting Procedure Table
Step
Actions and Questions
Check the Fuser for correction installation.
1
Is the Fuser correctly installed?
Does the error still occur?
2
Replace the Fuser (page 8-10). Does the
3
error still occur?
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
■
page 10-10
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Fuser" on page 10-46
■
Yes
Go to step 3.
Go to step 3.
Replace the
MCU Board
(page 8-87).
Phaser 6180 Color Laser Printer Service Manual
No
Reseat the
Fuser. Go to
step 2.
Complete.
Complete.