Load Tray 3 (No Suitable Paper) - Xerox Phaser 6180 Service Manual

Load Tray 3 (No Suitable Paper)

Phaser 6180 Color Laser Printer Service Manual
The type or size of paper mismatched or Tray 3 is empty.
Applicable Chain Link
■ Chain Link
Initial Actions
■
Inspect the tray to ensure that it is free of obstructions, is loaded with
supported paper, and the Guides are adjusted correctly.
■
Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Tray 3, PL12.3.1
■
Size Switch, PL7.1.18
■
MCU Board, PL9.1.20
■
Registration Sensor Harness,
■
PL3.2.37
Right Side Harness, PL10.1.15
■
Registration Sensor, PL3.2.30
■
Feeder Unit, PL3.2.1
■
No Paper Actuator, PL3.2.49
■
C2 Chute Harness, PL12.2.7
■
Tray 3 Feeder Harness, PL12.2.3
■
Tray 3 Feeder, PL12.1.1
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the paper size. Does the paper
size meet specifications?
Check the paper size setting. Does the
2
paper match with the settings in the
Control Panel?
024-960: Load Tray 3
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
■
page 10-10
"Map 2 - Laser Unit" on page 10-11
■
"Map 4 - LVPS and MCU Board" on
■
page 10-13
"Main Drive" on page 10-34
■
"Feeder" on page 10-36
■
"Tray 1 (MPT) and Registration" on
■
page 10-32
"Optional 550-Sheet Feeder Wiring
■
Diagram" on page 10-50
Error Messages and Codes
Yes No
Go to step 2. Replace the
paper with the
correct
specifications.
Go to step 3. Correct the
paper settings
in the Control
Panel. Go to
step 3.
3-65