Configuring An Ldp Pw (Vlan Mode) - HP 10500 Series Configuration Manual

Configuring an LDP PW (VLAN mode)

Network requirements
Create an LDP PW between PE 1 and PE 2 over the backbone so VLAN 10 on CE 1 can communicate
with VLAN 20 on CE 2.
Figure 66 Network diagram
Device
PE 1
PE 2
Configuration procedure
Before you perform the following configurations, configure VLANs and add ports to VLANs on switches.
Configure CE 1:
1.
<CE1> system-view
[CE1] interface ten-gigabitethernet 1/0/1
[CE1-Ten-GigabitEthernet1/0/1] port link-type trunk
[CE1-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10
[CE1-Ten-GigabitEthernet1/0/1] quit
Configure PE 1:
2.
# Configure an LSR ID.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
# Enable L2VPN.
[PE1] l2vpn enable
# Enable global LDP.
[PE1] mpls ldp
Interface IP address
Loop0 192.2.2.2/32
Vlan-int20 10.1.1.1/24
Loop0 192.3.3.3/32
Vlan-int30 10.2.2.1/24
Device Interface
P Loop0
Vlan-int20
Vlan-int30
240
IP address
192.4.4.4/32
10.1.1.2/24
10.2.2.2/24