HP 10500 Series Configuration Manual page 221

[PE2-LoopBack0] isis enable 1
[PE2-LoopBack0] quit
# Create VPN instance vpn1, and configure the RD and route target attributes for it.
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 11:11
[PE2-vpn-instance-vpn1] vpn-target 3:3 import-extcommunity
[PE2-vpn-instance-vpn1] vpn-target 3:3 export-extcommunity
[PE2-vpn-instance-vpn1] quit
# Configure interface Loopback 1, and bind the interface to VPN instance vpn1.
[PE2] interface loopback 1
[PE2-LoopBack1] ip binding vpn-instance vpn1
[PE2-LoopBack1] ipv6 address 2001:1::2 128
[PE2-LoopBack1] quit
# Start BGP on PE 2.
[PE2] bgp 600
# Configure the capability to advertise labeled routes to IBGP peer 4.4.4.9 and to receive labeled
routes from the peer.
[PE2-bgp] peer 4.4.4.9 as-number 600
[PE2-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE2-bgp] ipv6-family unicast
[PE2-bgp-ipv4] peer 4.4.4.9 enable
[PE2-bgp-ipv4] peer 4.4.4.9 label-route-capability
[PE2-bgp-ipv4] quit
# Configure the maximum hop count from PE 2 to EBGP peer 2.2.2.9 as 10.
[PE2-bgp] peer 2.2.2.9 as-number 100
[PE2-bgp] peer 2.2.2.9 connect-interface loopback 0
[PE2-bgp] peer 2.2.2.9 ebgp-max-hop 10
# Configure peer 2.2.2.9 as a VPNv6 peer.
[PE2-bgp] ipv6-family vpnv6
[PE2-bgp-vpnv6] peer 2.2.2.9 enable
[PE2-bgp-vpnv6] quit
# Redistribute direct routes to the routing table of vpn1.
[PE2-bgp] ip vpn-instance vpn1
[PE2-bgp-vpn1] ipv6-family unicast
[PE2-bgp-ipv6-vpn1] import-route direct
[PE2-bgp-ipv6-vpn1] quit
[PE2-bgp-vpn1] quit
[PE2-bgp] quit
Verify the configuration:
5.
# PE 1 and PE 2 can ping each other. Take PE 1 as an example:
[PE1] ping ipv6 -a 2001:1::1 -vpn-instance vpn1 2001:1::2
PING6(104=40+8+56 bytes) 2001:1::1 --> 2001:1::2
56 bytes from 2001:1::2, icmp_seq=0 hlim=64 time=1.000 ms
56 bytes from 2001:1::2, icmp_seq=1 hlim=64 time=0.000 ms
56 bytes from 2001:1::2, icmp_seq=2 hlim=64 time=0.000 ms
215