Configuring Routing Between An Ipv6 Mce And A Pe - HP 10500 Series Configuration Manual

Step
1. Enter system view.
2. Enter BGP view.
3. Configure the MCE as an
IBGP peer.
4. Create and enter BGP IPv6
address family view.
5. Enable BGP to exchange IPv6
unicast routing information
with the IBGP peer.
6. (Optional.) Redistribute the
IGP routes of the VPN.

Configuring routing between an IPv6 MCE and a PE

IPv6 MCE-PE routing configuration includes these tasks:
Bind the IPv6 MCE-PE interfaces to IPv6 VPN instances
•
Perform routing configurations
•
• Redistribute IPv6 VPN routes into the routing protocol running between the IPv6 MCE and the PE.
Configuring IPv6 static routing between an IPv6 MCE and a PE
Step
1. Enter system view.
2. Configure IPv6 static
routes for an IPv6 VPN
instance.
3. (Optional.) Configure
the default precedence
for IPv6 static routes.
Configuring RIPng between an IPv6 MCE and a PE
Command
system-view
bgp as-number
peer { group-name |
ipv6-address } as-number
as-number
ipv6-family [ unicast ]
peer { group-name |
ipv6-address } enable
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
Command
system-view
ipv6 route-static vpn-instance s-vpn-instance-name
ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address } [ permanent ]
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
ipv6 route-static default-preference
default-preference-value
35
Remarks
N/A
N/A
By default, no BGP peer is
configured.
N/A
By default, BGP cannot exchange
IPv6 unicast routing information
with a peer.
By default, BGP does not
redistribute routes from any other
routing protocol.
A VPN site must advertise the IPv6
VPN network addresses it can
reach to the connected IPv6 MCE.
Remarks
N/A
By default, no IPv6
static route is
configured.
If you do not
specify a default
preference value,
the default
preference value is
60.