HP 10500 Series Configuration Manual page 37

Step
2. Configure an IPv6 static route
for an IPv6 VPN instance.
3. (Optional.) Configure the
default precedence for IPv6
static routes.
Configuring RIPng between an IPv6 MCE and a VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on an IPv6 MCE, you allow routes of different
VPNs to be exchanged between the IPv6 MCE and the sites through different RIPng processes, ensuring
the separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between an MCE and a VPN site:
Step
1. Enter system view.
Create a RIPng process for a
2.
VPN instance and enter RIPng
view.
3. Redistribute remote site routes
advertised by the PE.
4. (Optional.) Configure the
default cost value for the
redistributed routes.
5. Return to system view.
6. Enter interface view.
7. Enable RIPng on the interface.
Configuring OSPFv3 between an IPv6 MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
Command
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ]
| vpn-instance d-vpn-instance-name
nexthop-address } [ permanent ] [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
ipv6 route-static default-preference
default-preference-value
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
31
Remarks
By default, no IPv6
static route is
configured.
Perform this
configuration on the
IPv6 MCE. On the
VPN site, configure
normal IPv6 static
routes.
The default setting is
60.
Remarks
N/A
Perform this configuration on the
IPv6 MCE. On the VPN site,
configure normal RIPng.
By default, no route of any other
routing protocol is redistributed
into RIPng.
If you do not specify a default cost
value, the default cost value is 60.
N/A
N/A
By default, RIPng is disabled.