HP 10500 Series Configuration Manual page 30

Figure 5 Network diagram
VPN 1
192.168.0.0/24
Configuration procedure
Configure VPN instances:
1.
Create VPN instances on the MCE and PE 1, and bind the VPN instances with VLAN interfaces.
For the configuration procedure, see
Configure routing between the MCE and VPN sites:
2.
# Enable an OSPF process on the devices in the two VPNs, and advertise the subnets. (Details not
shown)
# Configure OSPF on the MCE, and bind OSPF process 10 with VPN instance vpn1 to learn the
routes of VPN 1.
<MCE> system-view
[MCE] ospf 10 router-id 10.10.10.1 vpn-instance vpn1
[MCE-ospf-10] area 0
[MCE-ospf-10-area-0.0.0.0] network 10.214.10.0 0.0.0.255
[MCE-ospf-10-area-0.0.0.0] quit
[MCE-ospf-10] quit
# Display the routing table of VPN 1 on the MCE.
[MCE] display ip routing-table vpn-instance vpn1
Destinations : 13
Destination/Mask
0.0.0.0/32
10.214.10.0/24
Vlan-int30: 30.1.1.2/24
Vlan-int40: 40.1.1.2/24
MCE
XGE1/0/1
Vlan-int10
VR 1
10.214.10.3/24
VPN 2
192.168.10.0/24
Routes : 13
Proto Pre
Direct 0
Direct 0
PE 1
XGE1/0/1
XGE1/0/3
Vlan-int30: 30.1.1.1/24
Vlan-int40: 40.1.1.1/24
XGE1/0/2
Vlan-int20
10.214.20.3/24
VR 2
"Using OSPF to advertise VPN routes to the
Cost NextHop
0 127.0.0.1
0 10.214.10.3
24
VPN 2
Site 1
CE 1
PE 2
PE 3
CE 2
VPN 1
Site 2
Interface
InLoop0
Vlan10
PE."