Enabling L2Vpn; Configuring An Ac - HP 10500 Series Configuration Manual

Tasks at a glance
Configuring a
•
(Optional.)
•
(Required.) Choose either of the following tasks to configure a PW:
Configuring a static PW
Configuring an LDP PW
(Required.)
(Optional.)
(Required.)

Enabling L2VPN

You must enable L2VPN so the PE can support MPLS L2VPN.
To enable L2VPN:
Step
1. Enter system view.
2. Enable L2VPN.
3. Configure an LSR ID for the
PE.
4. Enter the view of the
backbone interface.
5. Enable MPLS.

Configuring an AC

An AC is a service instance on a Layer 2 Ethernet interface that connects to a CE.
After you configure a service instance on a Layer 2 Ethernet port, the Layer 2 Ethernet port uses the
service instance to match received packets.
To configure a service instance on a Layer 2 Ethernet interface:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Create a service instance
and enter service instance
view.
PW:
Configuring a PW class
Binding an AC to a VSI
Configuring PE dual homing
Configuring MAC address learning
Command
system-view
interface interface-type
interface-number
service-instance instance-id
Command
system-view
l2vpn enable
mpls lsr-id lsr-id
interface interface-type
interface-number
mpls enable
269
Remarks
Choose a PW configuration
method depending on the VPLS
implementation.
N/A
N/A
N/A
Remarks
N/A
By default, L2VPN is disabled.
By default, no LSR ID is configured.
For more information about this
command, see MPLS Command
Reference.
N/A
By default, MPLS is disabled on an
interface.
Remarks
N/A
N/A
By default, no service instance is
created.