HP 10500 Series Configuration Manual page 260

Figure 69 Network diagram
Device
CE 1
PE 1
CE 2
Configuration procedure
Before you perform the following configurations, configure VLANs and add ports to VLANs on CEs.
Configure CE 1:
1.
<CE1> system-view
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
[CE1-Vlan-interface10] quit
Configure PE 1:
2.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
# Configure an LSR ID.
[PE1] mpls lsr-id 192.2.2.2
# Enable L2VPN.
[PE1] l2vpn enable
# Configure a tunnel between PE 1 and P.
# Create a service instance on Ten-GigabitEthernet 1/0/1 connected to CE 1.
[PE1] interface ten-gigabitethernet 1/0/1
[PE1-Ten-GigabitEthernet1/0/1] service-instance 1000
[PE1-Ten-GigabitEthernet1/0/1-srv1000] encapsulation s-vid 10
[PE1-Ten-GigabitEthernet1/0/1-srv1000] quit
[PE1-Ten-GigabitEthernet1/0/1] quit
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int23 23.1.1.1/24
Vlan-int10 100.1.1.2/24
Device Interface
P Loop0
Vlan-int23
Vlan-int26
PE 2 Loop0
Vlan-int26
254
IP address
192.4.4.4/32
23.1.1.2/24
26.2.2.2/24
192.3.3.3/32
26.2.2.1/24