Configuring A Static Lsp; Overview; Configuration Prerequisites; Configuration Procedure - HP 10500 Series Configuration Manual

Configuring a static LSP

Overview

A static label switched path (LSP) is established by manually specifying the incoming label and outgoing
label on each node (ingress, transit, or egress node) of the forwarding path.
Static LSPs consume fewer resources, but they cannot automatically adapt to network topology changes.
Therefore, static LSPs are suitable for small and stable networks with simple topologies.
Follow these guidelines to establish a static LSP:
• The ingress node determines an FEC for a packet according to the destination address, inserts the
label for that FEC into the packet, and forwards the packet to the next hop or out of the outgoing
interface. Therefore, on the ingress node, you must specify the outgoing label for the destination
address (the FEC) and the next hop or the outgoing interface.
A transit node swaps the label carried in a received packet with a specific label, and forwards the
•
packet to the next hop or out of the outgoing interface. Therefore, on each transit node, you must
specify the incoming label, the outgoing label, and the next hop or the outgoing interface.
• If the penultimate hop popping function is not configured, an egress node pops the incoming label
of a packet, and performs label forwarding according to the inner label or IP forwarding. Therefore,
on the egress node, you only need to specify the incoming label.
The outgoing label specified on an LSR must be the same as the incoming label specified on the
•
directly-connected downstream LSR.

Configuration prerequisites

Before you configure a static LSP, complete the following tasks:
Identify the ingress node, transit nodes, and egress node of the LSP.
•
Enable MPLS on all interfaces that participate in MPLS forwarding. For more information, see
•
"Configuring basic
Make sure that the ingress node has a route to the destination address of the LSP. This is not required
•
on transit and egress nodes.

Configuration procedure

To configure a static LSP:
Step
1. Enter system view.
2. Configure the
ingress node of the
static LSP.
MPLS."
Command
system-view
static-lsp ingress lsp-name destination
dest-addr { mask | mask-length } nexthop
next-hop-addr out-label out-label
54
Remarks
N/A
If you specify a next hop for the
static LSP, make sure the ingress
node has an active route to the
specified next hop address.