HP 10500 Series Configuration Manual page 169

# Allow the local AS number to appear in the AS-PATH attribute of the routes received.
[PE3-bgp-vpnv4] peer 2.2.2.9 allow-as-loop 2
[PE3-bgp-vpnv4] quit
[PE3-bgp] quit
# Configure CE 1.
[CE1] bgp 200
[CE1-bgp] peer 1.1.1.9 as-number 200
[CE1-bgp] peer 1.1.1.9 connect-interface loopback 0
[CE1-bgp] ipv4-family vpnv4
[CE1-bgp-vpnv4] peer 1.1.1.9 enable
[CE1-bgp-vpnv4] undo policy vpn-target
[CE1-bgp-vpnv4] quit
[CE1-bgp] quit
# Configure PE 4 and CE 2 in the same way that PE 3 and CE 1 are configured. (Details not
shown.)
Verify the configurations:
7.
Execute the display ip routing-table command on PE 1 and PE 2 to verify that the public routing
tables contain only routes on the service provider network. Take PE 1 as an example:
[PE1] display ip routing-table
Destinations : 15
Destination/Mask
0.0.0.0/32
3.3.3.9/32
4.4.4.9/32
30.1.1.0/24
30.1.1.0/32
30.1.1.1/32
30.1.1.255/32
30.1.1.2/32
127.0.0.0/8
127.0.0.0/32
127.0.0.1/32
127.255.255.255/32
224.0.0.0/4
224.0.0.0/24
255.255.255.255/32
# Execute the display ip routing-table vpn-instance command on PE 1 and PE 2 to verify that the
VPN routing tables contain sub-VPN routes. Take PE 1 as an example:
[PE1] display ip routing-table vpn-instance vpn1
Destinations : 9
Destination/Mask
0.0.0.0/32
11.1.1.0/24
Routes : 15
Proto Pre Cost
Direct 0 0
Direct 0 0
ISIS 15 10
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Routes : 9
Proto Pre Cost
Direct 0 0
Direct 0 0
163
NextHop Interface
127.0.0.1 InLoop0
127.0.0.1 InLoop0
30.1.1.2 Vlan2
30.1.1.1 Vlan2
30.1.1.1 Vlan2
127.0.0.1 InLoop0
30.1.1.1 Vlan2
30.1.1.2 Vlan2
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
0.0.0.0 NULL0
0.0.0.0 NULL0
127.0.0.1 InLoop0
NextHop Interface
127.0.0.1 InLoop0
11.1.1.1 Vlan1