Configuring Mpls L3Vpn Inter-As Option C - HP 10500 Series Configuration Manual

# Bind the interface connected with CE 2 to the created VPN instance.
[PE2] interface Vlan-interface12
[PE2-Vlan-interface12] ip binding vpn-instance vpn1
[PE2-Vlan-interface12] ip address 20.0.0.1 8
[PE2-Vlan-interface12] quit
# Enable BGP on PE 2.
[PE2] bgp 600
# Configure IBGP peer 4.4.4.9 as a VPNv4 peer.
[PE2-bgp] peer 4.4.4.9 as-number 600
[PE2-bgp] peer 4.4.4.9 connect-interface loopback 0
[PE2-bgp] ipv4-family vpnv4
[PE2-bgp-vpnv4] peer 4.4.4.9 enable
[PE2-bgp-vpnv4] quit
# Redistribute direct routes to the VPN routing table of vpn1.
[PE2-bgp] ip vpn-instance vpn1
[PE2-bgp-vpn1] ipv4-family unicast
[PE2-bgp-ipv4-vpn1] import-route direct
[PE2-bgp-ipv4-vpn1] quit
[PE2-bgp-vpn1] quit
[PE2-bgp] quit
Verify the configuration:
5.
PE 1 and PE 2 can ping each other. Take PE 1 as an example:
[PE1] ping -a 30.0.0.1 -vpn-instance vpn1 20.0.0.1
PING 20.0.0.1 (20.0.0.1) from 30.0.0.1: 56 data bytes
56 bytes from 20.0.0.1: icmp_seq=0 ttl=255 time=0.000 ms
56 bytes from 20.0.0.1: icmp_seq=1 ttl=255 time=0.000 ms
56 bytes from 20.0.0.1: icmp_seq=2 ttl=255 time=0.000 ms
56 bytes from 20.0.0.1: icmp_seq=3 ttl=255 time=0.000 ms
56 bytes from 20.0.0.1: icmp_seq=4 ttl=255 time=0.000 ms
--- 20.0.0.1 ping statistics ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/stddev = 0.000/0.000/0.000/0.000 ms

Configuring MPLS L3VPN inter-AS option C

Network requirements
Site 1 and Site 2 belong to the same VPN. Site 1 accesses the network through PE 1 in AS 100, and Site
2 accesses the network through PE 2 in AS 600. PEs in the same AS run IS-IS.
PE 1 and ASBR-PE 1 exchange labeled IPv4 routes through MP-IBGP. PE 2 and ASBR-PE 2 exchange
labeled IPv4 routes through MP-IBGP. PE 1 and PE 2 exchange VPNv4 routes through MP-EBGP.
ASBR-PE 1 and ASBR-PE 2 use their respective routing policies and label routes received from each other.
ASBR-PE 1 and ASBR-PE 2 use MP-EBGP to exchange labeled IPv4 routes.
143