Table of Contents
Advertisement
[992] Ethernet IP Address
This Section will display the IP address of the Ethernet connection. This value is
programmed in Section [001] or assigned by DHCP .
[993] Ethernet Gateway Address
This Section will display the IP address of the Ethernet Gateway. This value is
programmed in Section [003] or assigned by DHCP .
[994] Cellular IP Address
This Section will display the current dynamic IP address assigned by DHCP to the
Cellular connection.
NOTE: Cellular uses DHCP (Dynamic IP) only. The Cellular IP address is always
provided by the Cellular network (i.e., not programmable).
[995] SIM Number
This Section will display the Subscriber Identity Module (SIM) number of the SIM
card installed in the Communicator. Format is: Major Industry Identifier (2 digits)
Mobile Country Code (2 or 3 digits); Mobile Network Code (2 - 3 digits); Unique
Number (10 - 12 digits); and Checksum (1 digit). Valid SIM numbers range is: 18 - 21
numbers. This number is printed on SIM and the outside of the Communicator
carton.
NOTE: The Checksum digit is omitted on 19-digit SIM Card numbers.
[996] Cellular Telephone Number
NOTE: This Section will display the Cellular telephone number of the SIM. This
telephone number is required by the Installer for DLS and remote firmware
(flash) update. User can access this telephone number by entering [*] [6] < >
"Cellular Phone No. " to display the phone number.
[997] IMEI Number
This Section will display the unique 15-digit International Mobile Equipment Identity
(IMEI) of the radio. Format is: Reporting Body Identifier (2 digits), Allocation Number
(4 digits); Final Assembly Code (2 digits); Serial Number (6 digits); and a check digit.
[998] MAC Address
This Section will display the unique12-digit, hexadecimal number assigned as the
Media Access Control (MAC) address of the device.
[999] Software Default
Default (99);
The Software default allows the installer to refresh the unit after changes and also
return the Communicator to the default state.
00: Default Module. All programming Sections in module revert to factory settings.
This will erase all existing programming of the unit.
55: Reset. The Communicator is reset. This option is equivalent to power cycling the
Communicator.
[984] Communicator Status
The communicator status sections are intended to provide the installer with real-time
status of the communicator's functionality, operational readiness, failures, and poten-
tial malfunctions that may affect flawless operation of the communicator and its pri-
mary function of sending signal to the central station in case the monitored event
occurs.
The communicator status is displayed in the form of a 6-digit CODE (6 hexadecimal
numbers) as in the following pattern: 00000F . The range of the code is from: 00000F
– 2220CF . Not all numbers in this range are assigned a status code (Some numbers
are skipped, i.e. not assigned the code).
S
R
YSTEM
C
OMMUNICATOR
D
ESET
EFAULTS
T
ROUBLESHOOTING
37
Advertisement
Table of Contents
