Table of Contents
Advertisement
number. Valid range: 0000000001 - FFFFFFFFFE. Programming all 0 or all F will cause
a Module Configuration Trouble (yellow LED = 12 flashes).
[202] Cellular Receiver 1 DNIS
Default (000000)
The DNIS is used in addition to the account code to identify the Communicator
module at the central station. Valid range: 000000 - 099999. Values are entered as
leading 0 followed by the five digit DNIS. Format is BCD.
NOTE: Each Ethernet/Cellular receiver must be programmed with a unique DNIS.
[203] Cellular Receiver 1 Address
Default (000.000.000.000)
Enter the Cellular Receiver 1 IP address. This information will be provided by your
central station system administrator. Each 3-digit segment of the address must be
within a valid range of 000-255.
NOTE: When a valid IP address has been entered, the Cellular is enabled and will
communicate events over the Cellular channel.
[204] Cellular Receiver 1 Port
Default (0BF5/3061)
This Section determines the port used by Cellular Receiver 1. Change the default
value of this port when your installation is located behind a firewall, and must be
assigned a particular port number as determined by your central station system
administrator. Valid range: 0000 - FFFF .
NOTE: Programming this Section with 0000 will disable the receiver.
[205] Cellular Receiver 1 APN
Default ( )
The Access Point Name (APN) determines the Cellular network that the
Communicator will connect to. This information is available from your network carrier.
Program this Section as 32 ASCII characters.
NOTE: When a SIM card with a custom APN is used, the unit will not have access to
the Internet. DLS and remote flash can still be done if Section [221] is
programmed with a valid Public APN.
[206] Cellular Receiver 1 Domain Name
Default ( )
i
Programming this Section is not permitted on a UL/ULC listed system.
Enter the Domain Name as 32 ASCII characters. This information will be provided by
your central station system administrator.
[211] Cellular Receiver 2 Account Code
Default (0000000000)
The account code is used by the central station to distinguish between different
transmitters. This account code is used when transmitting signals to the central
station receiver. Signals received on the panel will use the panel account number.
Valid range: 0000000001 - FFFFFFFFFE.
NOTE: Programming this Section as all 0 or F will cause a Module Configuration
Trouble (yellow LED = 12 flashes).
[212] Cellular Receiver 2 DNIS
Default (000000)
The DNIS is used in addition to the Account Code to identify the Communicator
module at the central station. Valid range: 000000 - 099999. Values are entered as a 0
followed by the 5 digit DNIS value. Format is BCD.
NOTE: Each Ethernet/Cellular receiver must be programmed with a unique DNIS.
C
R
ELLULAR
ECEIVER
2 O
PTIONS
29
Advertisement
Table of Contents
