Installing Cat 5 Cable (Tl2553G Only); Inserting/Removing The Sim Card - DSC 3G2055 Installation Manual

Hspa/3g wireless alarm communicator ethernet/internet and hspa/3g dual-path alarm communicator
Hide thumbs Also See for 3G2055:
Table of Contents

Advertisement

A Category 5 (CAT 5) ethernet cable must
be run from a source with Ethernet/Inter-
net connectivity to the Communicator
module, inside the Self Contained Wire-
less Control Panel cabinet. The Communi-
cator end of the cable must have an RJ-45
plug, which connects to the Communica-
tor's RJ-45 jack. All requirements for instal-
lation of CAT5 ethernet cable must be
observed for correct operation of the Com-
municator, including, but not limited to, the
following:
• Do NOT strip off cable sheathing more
than required for proper termination.
• Do NOT kink/knot cable.
• Do NOT crush cable with cable ties.
• Do NOT untwist CAT5 pairs more than
1.2cm (½").
• Do NOT splice cable.
• Do NOT bend cable at right angles or make any other sharp bends.
NOTE: CAT5 specification requires that any cable bend must have a minimum 5 cm (2
in.) bend radius. Maximum length of CAT 5 cable is 100m (328 ft.).
NOTE: The Ethernet cable shall not be visible when the installation is complete
unless the install is a surface mount installation.
I
NSERTING
R
EMOVING THE
C
ARD
1. Remove
the
cover of the SCW
Control
Panel
access SIM
holder.
2. Remove power from
the
SCW
disconnect the backup battery connections.
3. On the SIM card holder push gently to slide the cover towards OPEN as indicated
by the arrow on SIM holder. This will unlatch the SIM card holder on the side
furthest from edge of the Communicator. See Figure 1.
4. Lift up the SIM card holder from the side that is not hinged.
NOTE: The SIM card can be damaged by bending or scratching contacts. Use caution
when handling the SIM card.
5. Insert or remove the SIM card, noting the orientation of the notches on the SIM
card and the SIM card holder.
6. When inserting a SIM card, insert the card in the proper orientation and gently
push the SIM card holder down and slide the holder as indicated by the arrow on
SIM holder, to LOCK.
I
CAT 5 C
NSTALLING
/
SIM
front
to
card
and
(TL2553G
ABLE
RJ-45 Connector
Figure 3: SIM Card Pinouts
DG0009396
SIM Card Pinouts
11
)
ONLY
Figure 2: RJ-45 Pinout

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tl2553g

Table of Contents