Table of Contents
Advertisement
ure the device to encrypt communications the next time the Communicator module
performs a communication to that receiver.
NOTE: Packets will start being encrypted only after the next event is sent to that
receiver, or if the unit is restarted.
C
C
SCW
OMMUNICATOR
ONFIGURATION WITH
NOTE: The Alarm Communicator is installed in the SCW prior to shipment by Digital
Security Controls (DSC). The Factory Installation includes insertion of the SIM card.
The SCW should not be mounted in its final location without performing a
Communicator Test to ensure adequate HSPA/3G coverage for the 3G2055 and
TL2553G Alarm Communicators
Figure 1: Communication Board Connection Points
LOCK
LOCK
I
L
NSTALLATION
OCATION
The Communicator shall be installed in an indoor location only.
This HSPA/3G/Ethernet Communicator shall be installed by Service Persons only.
(Service Person is defined as a person having appropriate technical training and expe-
rience necessary to be aware of hazards to which that person may be exposed in per-
forming a task and of measures to minimize the risks to that person or other
persons). The Communicator shall be installed and used within an environment that
provides the pollution degree max 2, over voltages category II, in non-hazardous,
indoor locations only. This manual shall be used with the Installation Manual of the
alarm control panel which is connected to the HSPA/3G/Ethernet Communicator. All
instructions specified within the control panel manual must be observed.
All the local rules imposed by local electrical codes shall be observed and respected
during installation.
10
Advertisement
Table of Contents
