Table of Contents
Advertisement
[213] Cellular Receiver 2 Address
Default (000.000.000.000)
Enter the Cellular Receiver 2 IP address. This IP address will be provided by your
central station. Format is 4 fields, each field is 3-digit decimal. Valid range: 000 - 255.
NOTE: When a valid address has been entered, Cellular Receiver 2 is enabled and will
communicate events over the Cellular path.
[214] Cellular Receiver 2 Port
Default (0BF5/3061)
This Section defines the port of Cellular Receiver 2. Change the value of this port
when your installation is located behind a firewall and must be assigned a particular
port number, as determined by your central station system administrator. Valid range:
0000 - FFFF .
NOTE: Do not program Cellular Receiver 1 and Cellular Receiver 2 to communicate to
the same receiver.
[215] Cellular Receiver 2 APN
Default ( )
The APN determines the Cellular network that the Communicator will connect to.
This information is available from your network carrier. Program this Section with up
to 32 ASCII characters.
NOTE: When a SIM card with a custom APN is used, the unit will not have access to
the internet. DLS and remote flash can still be done if Section [221] is
programmed with a valid Public APN.
[216] Cellular Receiver 2 Domain Name
Default ( )
i
Programming this Section is not permitted on a UL/ULC listed system.
Enter the Cellular Receiver 2 Domain Name with up to 32 ASCII characters.
[221] Cellular Public Access Point Name
Default ( )
When the Communicator is operating on a private APN, use this Section to select a
public APN for DLS and Remote Firmware Update. This information is available from
your network carrier. The APN identifies the public Cellular network that the
Communicator will connect to.
[222] Cellular Login User Name
Default ( )
Some network carriers require you to provide login credentials when connecting to
an APN. Program your login User Name in this Section. Format is up to 32 ASCII
characters.
NOTE: This Section is not accessible via SCW keypad programming.
[223] Cellular Login Password
Default ( )
Some network carriers require you to provide login credentials when connecting to
an APN. Program your login Password in this Section.
Format is up to 32 ASCII characters.
[224] Cellular Test Transmission Time of Day
Default (9999)
Enter a 4 digit value using the 24-hour clock format (HHMM) to set the test
transmission time of day. Valid range: 00-23 for the hours (HH) and 00-59 for the
minutes (MM).
C
O
ELLULAR
PTIONS
30
Advertisement
Table of Contents
