Command And Control Options - DSC 3G2055 Installation Manual

NOTE: To disable the test transmission time of day enter 9999 or FFFF in this
Section.
The internal date and time will be automatically programmed by the primary receiver
only.
[225] Cellular Test Transmission Cycle
Default (000000)
This value represents the interval in between test transmissions in minutes. Valid
range: 000000 - 999999 minutes. Once the unit has sent the initial periodic test
transmission, all future test transmissions will be offset by the programmed number
of minutes. See Sections [026] - [029].
Table 13: Cellular Test Transmission Interval
Test Transmission Interval Daily Weekly Monthly
Programmed Minutes 001440 010080 043200
NOTE: Minimum value is 000005 minutes. Programming an interval that is less than
5 minutes will disable test transmission.
[226] Trouble Delay
Default (0F)
This option is used to program the delay, in minutes, for reporting an Ethernet
Trouble, Cellular Network, Insufficient Signal Strength, or Receiver Supervision
Trouble to the panel. The timer is only activated when Option 8 in [851][006], Trouble
Suppression is enabled.
Valid entries are 00-FF .
00 = No Delay
FF = Cellular Network Trouble, Ethernet Trouble, Low Signal Strength and Receiver
Supervision Trouble conditions are disabled.
01 - FE = Trouble Delay time in minutes.
[227] Voice Call Timeout
Default (00);
This option sets the Voice Call Timeout, in minutes. Programming a value of 00 will
disable timeout. Valid range is 00 to FF .
[228] Voice Call Back Time
Default (0A);
This option sets the Voice call back time, in minutes. When the Communicator
requests Call Back from the receiver, it will answer incoming calls during the pro-
grammed timeout period. If an incoming call is received after the timeout from
requesting call back, the Communicator will answer the call and immediately hang
up. Programming a value of 00 will disable timeout (accept all incoming calls). Default
value is 0A/10 seconds. Valid range is 00 to FF .
[229] Voice Call Back Number
Default (SIM Telephone Number);
This option sets the Voice Call Back Telephone Number for the receiver. This number
is used for Two Way calling. Current SIM telephone number can be viewed in Section
[996]. Valid entry is 32 character ASCII.
C C O
OMMAND AND ONTROL PTIONS
[301] Command and Control Toggle Options
[1] SMS Notification Default (ON)
.
[2] Reserved Default ( )
.
[3] SMS Command and Control Default (ON).
31