Table of Contents
Advertisement
C
OMMUNICATOR
C24 C
OMMUNICATIONS
(Before Installation)
Installation of the Communicator requires activation with Connect24 before opera-
tion. Dealer application forms and additional information on the Connect24 Voice
Response Unit (VRU) and graphical user interface (GUI) can be found at http://
www.Connect24.com or by telephone at: USA 1-888-251-7458 or CANADA 1-888-
955-5583.
IMPORTANT: Prior to installing a 3G2055 or TL2553G Communicator, contact your
monitoring station to determine if it is a master re-seller or visit http://www.Con-
nect24.com to become an authorized dealer. In either instance, you will require a Pro-
file Number, Installer ID Number, and an Installer Password. Perform the following
pre installation:
1. Retrieve the installer account and password from the master reseller, or from
Connect24 directly.
2. Connect
your
www.Connect24.com or use the mobile website m.connect24.com.
3. Log in to the Connect24 website using your installer account and password.
4. Perform the following steps in a Connect24 session to activate the SIM card and
initialize programming:
a. Navigate to the Initialize an account section.
b. Select Profile (This information will be provided by the master reseller or by
Connect24).
c. Select Product Module.
d. Enter the SIM card number.
e. Click Next then enter in all relevant information as required.
f. Confirm all information is entered correctly before submitting.
5. Repeat Step 4 to program another SIM card (i.e. another Subscriber), or log out
from Connect24.
6. When you are at the physical installation site, the Communicator will automatically
connect and download its programming from Connect24 once the unit is
initialized.
NOTE: Following initial installation, you can log in to the Connect24 website at any
time to re-configure the Communicator remotely, using the account created for this
installation. For more information, refer to the Connect24 website.
Before leaving the installation site, the Communicator TL2553G shall be
connected via an APPROVED (acceptable to the local authorities) Network
Interface Device (NID) (e.g., for UL Installations, U60950 listed NID). All wiring
shall be performed according to the local electrical codes.
The Communicator uses 128 Bit AES Encryption. Encryption can only be enabled
from the monitoring station receiver. Each receiver can independently have encryp-
tion enabled or disabled. When encryption is enabled, the central station will config-
1. Connect24, DSC, and DLS IV are Registered Trademarks of Tyco International Ltd. and its respective Com-
panies. All Rights Reserved.
P
I
RE
NSTALLATION
1
™
A
CCOUNT AND
browser
to
the
E
NCRYPTION
C
SIM
Connect 24
9
ONFIGURATION
A
CARD
CTIVATION
website
at:
http://
Advertisement
Table of Contents
