Subaru 1600 Service Manual page 645

13. Roof Moulding
1) (Hardtop) Cut off the heads of
three rivets fixing roof moulding to
front pillar.
2) (Hatchback and Station Wagon)
Remove joint between front and rear
roof mouldings.
3) Detach (front and rear) moulding
(along with clip) by pulling it with
fingers or cloth wound around screw-
driver so as not to damage body
surface.
4) Install (new) roof moulding to
drip rail by depressing it with hand.
(Hardtop only)
(Others)
Roof lTjoulding
Oepressing
Drip rail
A24·605
Fig. 14-165
BODY
5) (Hardtop) Install roof moulding
to front pillar with a blind rivet.
14. Rear Pillar
Moulding (Sedan)
1) Remove upper rear pillar turn
panel from inside of vehicle.
2) Remove two nuts through service
holes.
A24-613
Fig. 14-166 Removing nuts
3) Take out rear pillar moulding with
rear end of roof moulding raised.
4) Installation can be carried out in
the reverse order of removal.
14-50
15. Sealer, Sealing
Parts and Insulator
1) Plate partition and borings of the
body are provided with sealing com-
pound so as to prevent water or dust
from entering the interior. After
repamng or overhauling, be sure to
apply the speCified sealing com-
pound.
2) Since entrance of water or dust
through some of gage holes or work
holes utilized in manufacturing body
might adversely affect the vehicle,
they are closed by plugs or sealing
tapes.
After repairing or overhauling, be sure
to close the holes again with the
specified parts.
3) To eliminate water leakage
through rear window weatherstrip.
4-Door Sedan and Hardtop are equip-
ped with drain tubes which are located
at both sides of trunk room interior.
,H ,.,
~ ~-,' -,"~"~,~~-"""",._,,,,,,
... , _ . _ '
"".'-'''''''''I'''''''''''! ______ .,... ______ - -_________ - - -