Subaru 1600 Service Manual page 613

5) Attach outer weatherstrip and
corner patch.
6) Attach sealing cover, connect
electric connector for door switch, and
then install seat belt retractor.
NOTE:
Attach sealing cover properly to
prevent water leakage.
7) Attach lower trim panel, upper
trim panel, rear pillar trim and arm
rest.
1 Rear pillar trim
2
Upper trim panel
3 Lower trim panel
Fig.
14-44
8) Attach regulator handle.
A24-441
9) Install seat belt shoulder anchor.
10) Install rear seat cushion and back
rest.
4) Power Window (Option)
Switches for power window are
provided on upper trim panels instead
of window regulator handles, and a
window regulator has a electric motor.
Removal, installation and adjustment
procedures are common to the side
window with (manual) window re-
gulator.
A24-690
Fig. 14-45 Switch for power window
BODY
A24-691
Fig.
14-46
Window regulator for
power window
NOTE:
a. When removing upper trim panel,
disconnect electric wires at con-
nectors.
Fig. 14-47 Electric wires and
connectors
A24-692
b. When taking out window regulator,
also disconnect electric wire at
connector.
4. Rear Quarter
Window on Sedan
and Hardtop
1) Removal
1) Remove inner trim.
2) Remove rear pillar moulding or
opera grille.
3) Remove rear quarter glass in the
same manner as windshield.
14-18
2
Weatherstrip
A24-421
Fig.
14-48
Rear quarter glasses
2) Installation
Install rear quarter glass in the same
manner as windshield.
NOTE:
a. Overlap the work cord at center
of front edge of rear quarter glass.
b. Apply a sealing agent (Cemedine
#366E) as shown following figure.
c. Make sure that there is no gap be-
tween weatherstrip and rear pillar
mOUlding.
A24-422
Fig. 14-49 Setting work cord
Rear pillar A24-423
2 Rear pillar moulding
Fig. 14-50 Sealing of rear quarter
glass (4-000r Sedan)
,t,
-'>.-~""",*",,,,,-
...
,~
...... -." ...
-,.,;~---
......
,~.~.--,
- , - , - - , - , . -... , - ,
,.I------~,-,-,------------------