Subaru 1600 Service Manual page 640

BODY
3. Front Hood
~
CV
DETAIL "A"
DETAIL "S"
DETAIL
"e"
DETAIL "0"
Fig. 14-147
1 Front hood
2 Grommet
3 Front hood release cable
4 Hood stay clip
5 Hood stay
• Adjustment
1) The forward and rearward, and
leftward and rightward adjustments of
the striker assembly and the lock
assembly are done by loosening the
installing bolts.
2) For upward and downward direc-
tions adjust depending upon the close
contact of the hood to baffer, the
stepped difference between the front
hood and the fender and the condi-
tion of an operating force of the
release cable.
The adjusting method is done by
loosening the lock nut of the striker,
and a length of the striker.
6 Hinge
7 Striker assembly
8 Front hood lock
9 Hinge bracket
10 Front hood bracket
Fig. 14-148 Adjusting striker
14-45
A24·310
11 Rubber plate
12
Clip
13 Bolt
14 Spring washer
15 Washer
• Hood Lock
Release Cable
A24-e78
1) Release cable from the follOwing
parts.
a. Lock assembly
b. Clip on radiator panel
c. Clips on wheel apron
d. Release bracket under instrument
panel
2) Attach (new) release cable as
be-
fore.
NOTE:
Confirm that the engagement of the
striker is correct and operation of the
release cable and locations of cable
dips are correct.