Meters And Gauges; Combination Meter Illumination; Canceling The Function For Meter/Gauge Needle Movement Upon Turning On The Ignition Switch; Speedometer - Subaru WRX-STI Owner's Manual

. If you depress the brake pedal
suddenly, the hazard warning flasher
may blink rapidly. For details, refer to
"Emergency Stop Signal" F7-31.

Meters and gauges

NOTE
Liquid-crystal displays are used in
some of the meters and gauges on
the combination meter. You will find
their indications hard to see if you wear
polarized glasses.
& Combination meter illumina-
tion
When the ignition switch is turned to the
ON position, the various parts of the
combination meter are illuminated in the
following sequence.
1. Warning lights, indicator lights, meter
needles, gauge needles illuminate.
2. Meter and gauge indications each
show MAX position.
3. Meter and gauge indications each
show MIN position.
4. Regular illumination (for driving) be-
gins.
NOTE
This sequence of operations may not
take place if you quickly turn the
ignition switch to start the engine. This
is not a malfunction.
Instruments and controls/Meters and gauges
& Canceling the function for
meter/gauge needle move-
ment upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the ON
position. To change the setting, perform
the procedures described in Gauge Initial
Movement F3-46.
& Speedometer
The speedometer shows the vehicle
speed. The digital speedometer can be
also displayed on the multi information
display.
! Speed warning chime (if equipped)
When the speed is over approximately
120 km/h (75 mph), a chime sounds.
3-9
– CONTINUED –