Subaru WRX-STI Owner's Manual page 64

1-36
Seat, seatbelt and SRS airbags/Child restraint systems
2. Remove the head restraint of the rear
seating position where the child restraint
system is to be installed.
3. While following the instructions sup-
plied by the child restraint system manu-
facturer, connect the connectors of the
child restraint system to the anchor bars.
When the connectors are fastened, make
sure that the adjacent seatbelts are not
caught.
1) Inserting aid
NOTE
If your child restraint system is pro-
vided with inserting aids, clip them to
the two ISOFIX anchor bars (or put
them between seatback and seat cush-
ion at the two ISOFIX fastening points)
before connecting the child restraint
system.
Position the two connectors just in
front of the two inserting aids. Then
insert the two connectors into the
inserting aids to connect the connec-
tors to the anchor bars.
The inserting aids make it easier to fit
the child restraint system with ISOFIX
and avoid damage to the seat.
4. Before seating a child in the child
restraint system, try to move it back and
forth and right and left to verify that it is
held securely in position.
5. If the child restraint system requires a
top tether, latch the hook onto the top
tether anchorage and tighten the top
tether. For additional instructions, refer to
Top tether anchorages F1-37.
For further information, refer to the in-
struction manual supplied by the child
restraint system manufacturer.