To Turn Off The Cruise Control; To Change The Cruising Speed - Subaru WRX-STI Owner's Manual

cruise control is canceled.
To resume the cruise control after it has
been temporarily canceled and with vehi-
cle speed of approximately 30 km/h (20
mph) or more, press the
switch to the RES side to return to the
original cruising speed automatically.
The cruise control set indicator in the
combination meter will automatically ap-
pear at this time.
& To turn off the cruise control
There are two ways to turn off the cruise
control:
. Press the cruise control main button
again.
. Turn the ignition switch to the ACC or
LOCK/OFF position (but only when the
vehicle is completely stopped).
& To change the cruising speed
! To increase the speed (by the "RES/
SET" switch)
RES/SET
Press the RES/SET switch to the RES
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.K. models:
The set speed can be increased 1 mph
(1.6 km/h) each time by pressing the
RES/SET switch to the
quickly.
Starting and operating/Cruise control
Except U.K. models:
The set speed can be increased 1 km/h
(0.6 mph) each time by pressing the RES/
SET switch to the RES side quickly.
! To increase the speed (by accel-
erator pedal)
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Press the RES/SET switch to the
SET side once. Now the desired speed
is set and the vehicle will keep running at
that speed without depressing the accel-
erator pedal.
NOTE
CVT models:
. If you depress the accelerator pedal
while the Sport Sharp (S#) mode is
selected, the select lever/gear position
indicator may change from the "D"
indication to the current gear position
indication.
. If you depress the accelerator pedal
fully while the Intelligent (I) mode or the
Sport (S) mode is selected, the trans-
mission will operate like a conventional
automatic transmission.
RES side
7-47
– CONTINUED –