Asl Overview - Precor TRM700-16 Base Service Manual

low - indicates an error has occurred but the machine is useable; and 4) pulsing yellow - indic-
ates a loss of major function was detected.

ASL Overview

An externally visible indicator of the current machine operational status. There are four
l
supported states: 1) solid blue - indicates normal operation, 2) pulsing blue - indicates
preventative maintenance is required; 3) solid yellow - indicates an error has occurred
but the machine is useable; and 4) pulsing yellow - indicates a loss of major function was
detected.
Because only one status color and state can be shown at a time, the condition states are
l
prioritized as follows from lowest to highest: Blue Solid (lowest), Blue Pulsing, Yellow
Solid, Yellow Pulsing (highest). Higher priority states are always shown before a lower
priority state, until cleared.
The console UPCA
l
tenance counter. During active operation (workout in progress) or during the pause
state, the console transmits the ASL state to the lower control board
Only direct error code and maintenance counter data is used to determine the current
l
machine ASL state. No special algorithms (e.g., user behavior) are utilized to determine
the status.
Error code operation: A logged system error code will cause the ASL to begin pulsing
l
yellow. If the error self-corrects, the ASL will change from pulsing to solid yellow.
Depending on the error code type, after the end of a workout, the solid yellow light will
either revert back to blue (or pulsing blue), or require the operator to do a manual reset
from the service menu.
1
Upper PCA board
2
Lower PCA board
Experience Series 700 Line Treadmills
1
determines the ASL state using inputs from the error log and main-
6 Troubleshooting
2
(LPCA ).
148