Driving Data (Multifunction Display) - Skoda OCTAVIA Owner's Manual

Operating the MAXI DOT display
Hold - display main menu

Press - return to a higher level in the menu
Turn - move in the selected menu
B
Press - confirm selected menu item
Note
Depending on equipment not all functions may be available. The system indi-
cates this by means of a text message on the Infotainment screen.

Driving data (Multifunction display)


Introduction
The driving data display is only possible with the ignition switched on. After
the ignition is switched on, the function that was last selected before switch-
ing off the ignition is displayed.
If vehicles with MAXI DOTdisplay do not show the journey data after switch-
ing on the ignition, select the menu item Journey data in the main menu and con-
firm » page 56.
The units can be adjusted in Infotainment in the menu
The journey data can be set/reset in Infotainment in the menu
Instrument cluster.
Note
The setting of the information display is stored in the active user account per-
sonalisation » page 58.
Information Overview
Overview of driving data (depending on the vehicle equipment).
Range - drive distance in km which can be covered with the existing tank ca-
pacity and with the same driving style. If you drive more efficiently this value
can increase. With G-TEC vehicles the following details are displayed - total
range / with natural gas / petrol.
54
Operation
Average fuel consumption - is calculated continuously since the last time the
memory was deleted. After erasing the memory, no data will appear for the
first 100 m driven. With G-TEC vehicles, the average consumption of fuel cur-
rently being used is displayed.
Current fuel consumption - when the vehicle is stationary or slowly moving,
the fuel consumption is displayed in l/h (--,- km/l appears on models for some
countries). With G-TEC vehicles the current consumption of the fuel currently
being used is displayed ( with regards to a stationary or slow moving vehicle,
the natural gas consumption is displayed in kg/h).
Oil temperature - if the temperature is lower than 50 °C or if there is a fault in
the system for checking the oil temperature, the  symbols are displayed.
Warning when the preset speed is exceeded - allows the setting of a speed
limit where, if exceeded, an acoustic warning signal and a warning message ap-
pears on the display of the instrument cluster.
Traffic sign recognition - traffic signs display
nition.
Current speed - digital speedometer.
Average speed - is calculated continuously since the last time the memory
was deleted. After erasing the memory, no data will appear for the first 300 m
/  →  → Units.
driven.

/  →  →
Driving route - distance driven since the last time the memory was deleted.

Driving time - driving time since the last time the memory was deleted.
Comfort consumers - information about the total consumption of the com-
fort consumers in l/h and a list of three consumers (e.g. air conditioning etc.),
which have the largest share of fuel consumption.
Refill amount After the consumption of about 10 litres of fuel from the fully
refuelled tank, an amount of fuel is displayed in litres. This amount can now be
safely refilled.
Natural gas qualityThe details of the quality of natural gas are displayed as a
percentage of between 70% to 100%. The higher the value of natural gas, the
lower is the consumption.
» page 251, Traffic sign recog-
