Driving Data (Multifunction Display) - Skoda Rapid Operating Instructions Manual

For vehicles with automatic transmission the recommended gear will be
shown provided the mode for manual switching (Tiptronic) is selected.
WARNING
The driver is always responsible for selecting the correct gear in different
driving situations, such as overtaking.

Driving data (Multifunction display)


Introduction
This chapter contains information on the following subjects:
Operation
Information overview
Warning when exceeding the set speed
Memory
The driving data display is only possible with the ignition switched on.
After the ignition is switched on, the function that was last selected before
switching off the ignition is displayed.
For vehicles with a MAXI DOT display, the menu item Driving data must be se-
lected and confirmed in the main menu
The setting of the units and the switching on / off the display of some infor-
mation is available possible in the Infotainment
tainment, chapter CAR - Vehicle Settings.
WARNING
Concentrate fully at all times on your driving! As the driver you are fully re-
sponsible for the operation of your vehicle.
40
Using the system
» page 42, MAXI DOT display.
» Operating instructions Info-
Operation
Fig. 27 Buttons / wheel: on the operating lever / on the multifunction
40
steering wheel
40

Read and observe
41
42
The selection as well as the settings of the data values can be operated with
the buttons on the operating lever as well as on the multi-function steering
wheel » Fig. 27.
Description of the operation
Button /
Action
dial
Briefly press at the top
A
or bottom
Press briefly
B
Turn upwards or down-
wards
C
Press briefly
Information overview

Read and observe
Overview of driving data (depending on the vehicle equipment).
on page 40 first.
Operation
Select data / set data values
View information / confirm specifica-
tion
Select data / set data values
View information / confirm specifica-
tion
on page 40 first.
