Skoda OCTAVIA Owner's Manual page 78

Light Assist
Fig. 69 Sensor window for the high-beam assistant / system on / off

Read and observe on page 73 first.
The system automatically switches the high beam on/off in accordance with
the existing traffic (other vehicles) and environmental conditions (e.g. driving
through a lit village).
The high beam on/off is controlled by a sensor or a camera
The system can be activated/deactivated in Infotainment in the menu
→  → Light → Light Assist,
Conditions for the system function
The system is activated.

The light switch is in the position .

The vehicle speed is over 60 km/h or for some countries more than 40

km/h.
The windscreen is clean in the sensor area.

Switch on the system
›
Push the lever into the sprung position
light  lights up in the instrument cluster display.
Switch off the system
›
If the high beam is switched on automatically, move the lever into the sprung
position . The warning light  goes out. The high beam turns off.
B
›
If the high beam is is not switched on automatically, move the lever into the
sprung position . The warning light  goes out. The high beam turns on.
A
76
Operation
» Fig. 69.

» Fig. 69 The following indicator
A
The high beam switches off automatically when the speed falls below 30 km/h
(but the system remains switched on).
If there is a fault, the error message will appear in the instrument cluster dis-
play. Seek help from a specialist garage.
WARNING
The system is used only for support, thus the driver is not released from his
obligation to manually adjust the main or low beam according to the given
ambient conditions (e.g. in unfavourable lighting and weather conditions, as
when passing poorly lit road users, if necessary, when the visual range of
the sensor is limited by an obstacle).
CAUTION
Do not cover the sensor - the system can be affected.
Note
The setting for the high-beam assistant in Infotainment is stored (depending
on the Infotainment type) in the active user account for personalisation
» page 58.
/ 
Fog lights/rear fog light

Read and observe
Switching on the fog lights/rear fog lights is possible under the following
conditions.
The lights switch is in position ,  or 

›
To switch on the front fog lights, pull the light switch to position
warning light illuminates in the instrument cluster.

Fig. 70
Light switch – switch on front
and rear fog lights
on page 73 first.
» Fig. 70.
; the
1
